Dual Function Light Bar Option
Wiring Your Dual Function Light Bar: With the All New Dual Function Light Bar Wiring Harness - wiring just got 100% simplified. When you purchase a Dual Function Wire Harness from Cali Raised LED - pair with our Dual Function Wire Harness and get the complete set up for a plug and play installation.
All you need to decide is the height of the switch that is included in your wiring harness kit, If you want to go the old school route, use these options below.
There are two ways you can wire your dual function bar depending on how you would like it to operate.
Two Wire Harness
Controlling Amber & White Lights Independently: If you want to control the amber and white separately then you will need 2 harnesses. With the 2 harnesses, this gives you the ability to run the Amber/White lights individually or all at the same time.
The LED bar will have 3 wires on it. BLACK, WHITE, GREEN
BLACK: Ground
WHITE: Power For The White LED's
GREEN: Power For The Amber LED's
The harness will have DT Plugs at the end. You will want to remove those plugs as they are not needed.
After the plugs are removed there will be red and black wires exposed. between both harnesses, you will have 2 red wires and 2 black wires.
You will want to connect the 2 black wires together and connect them to the black wire on the LED bar, Then one red to the white and the other red to green. That will give you the ability to run the lights independently.
One Wire Harness
Controlling ALL Lights At Once: If you are wanting the full bar to turn on/off at once and not be able to control separately then you would just need one harness. Remove the plug from the harness. Connect the black wire from the LED bar to the black wire on the harness. Then combine the green and white wire on the LED bar to connect to the red on the harness.
Weight Limitations: Most vehicles are rated for no more than 500 lbs of weight limit to the top of the vehicle. Our racks are rated to withstand well over 1000lbs amount, which will exceed the rating for the vehicle. See report on running just (1) Extrusion Bar with over 200lb load! With 9 Extrusion bars on this rack, it's the vehicle itself that then becomes the limit to what weight you can load up on it!
Wiring: For lighting the complete lighting package, do not offer a harness at this time, but a custom harness is in the works!
We only offer the wiring harness for the Front Light Bar. For the Side Lighting options, please see below. The best place to start on getting your roof rack wired up would be to contact a shop in your local area, look for a shop that does 12V wiring. Look for an automotive accessories shop or a 4Wheel Parts store or equivalent that also does installations. We can't recommend a particular shop as everyone's quality of work differs. We highly recommend asking the shop for examples of their work before hiring them to wire your rack. A poor wiring job can result in a fire, so make sure you research them properly!
